Articles

Electronic Analog Thermometer


               

 An inexpensive electronic thermometer is capable of measuring temperatures over a range of from -30°F to +120°F. A diode-connected 2N3904 transistor used as the temperature sensor forms a voltage divider with Rl. As temperature increases, the volt­age drop across the transistor changes by approximately -1.166 millivolts-per degree F. As a result, the current at pin 3 of ICl, a 741 op amp with a gain of 5, decreases as the temperature measured by the sensor increases.

A second 741 op amp, IC2 is configured as an inverting amplifier. Resistors R5 and R6 calibrate the circuit. Calibration is also straightforward. When properly done, a temperature of -30°F will result in a meter reading of 0 milliamps, while a temperature of 120°F will result in a meter reading of 1 milliamp. Divide the scale between those points into equal segments and mark the divisions with the appropriate corresponding temperatures. The calibration is completed by placing the sensor in an environment with a known temperature, such as an ice-point bath. Place the sensor in the bath and adjust R6 until you get the correct meter reading. 



Schematic

 © Copyright Diwakar Bista. || This site is best viewed on 1024x768 resolution.

  Designed and Developed by Ajita Poudel.

Sunday the 21st. 888Poker.
Copyright 2012

©